flippyb

Holster, is it fine or are rivets silver or black? Detonator, 190mm length

mic tips Male popper, top left front of AB plate

Daylight shots of the helmet, as requested

MP40 ammo pouches, are these ok? (quality nowhere near as good as my others)

Helmet stickers, I know the silver is wrong but what about the rest? Helmet, filled it in a little more the joint at the back, how's it looking? [/img]

Hi Peps More pictures and questions...soz cod piece, do these snaps and rivet look correct? (15mm snaps and 8mm rivet) helmet in day light with light belt, and the drop boxes do line up with edge of belt when they hang

Sorry to be a pain but can someone post pics of the poppers for the bottom of cod piece to butt plate. On a second note do i need a male snap on top left of an plate, if so how far in and down, in measurements (pic)

Thermal detonator, right needs more coats of black paint, it is roughly 190mm from end of cap to end of cap. But my questions are, are the width of the caps too wide, if so what do you suggest? Question 2, silver clips with black rounded slotted screws ok - same as stormy?

Hi All, thanks for the advice, how does this look now? 2nd question, the outer mic is a black metal case, with mesh for the mic tips, any advice on how to attach this to the helmet?

mics, base is this black or should it be white, mic tips are they silver, just clear glue them onto helmet....soz think I asked a similar question before? ab plate/kidney plate rivets 8mm, paint these black?

Update, advice on where to paint (I have the humbrol matt 11) inside bucket side view side view front/side front view rear view

Hi all Sorry couldn't get image to upload, but are these boots ok for approval? https://images-na.ssl-images-amazon.com/images/I/6179YsQ27aL._UY500_.jpg

Oops missed the front chest and rear plate Front chest plate Rear plate Straps 5 rungs to edge

Lots of questions here guys, advice most welcome Hand guards mesh which one? my straps Shoulder Bells MP40 ammo leather pouches Mics Question, should the base of these mics be white or can they be black...hope this makes sense to someone? Knee pack Main Belt

Forearms Q1. Finishing strips 15mm? before I add them to seal the forearms up? Q2. Return edge towards the hands, am I right in thinking I can cut / sand this away?