Ren
-
Posts
20 -
Joined
-
Last visited
-
Days Won
2
Ren's Achievements
-
These are today's vacuum work.
-
The digital repair of the chest and back armor has been completed.
-
OII repair completed, it will be made of resin material.
-
These are the attachments of the thighs, and their performance is also good.
-
This is a vacuum test for the thighs and buttocks. I think it looks pretty good.
-
The fifth version of the helmet mold has been completed and is ready for production. I hope it can be successful this time 😄
-
Some molds are ready, I will conduct some vacuum tests tomorrow. This is a comparison between the old mold and the new mold.
-
The arm mold has been completed and is currently being produced.
-
This is the front mold for the waist, which took me 9 hours to rebuild. The sudden drop in temperature caused the failure of thigh mold printing, and it needs to continue to work hard.
-
I used a 2mm ABS vacuum for it, and I added a gas storage tank to my vacuum pump to enhance its power. It looks pretty good and is almost identical to the original statue. I will be working on the molds for the shoulders and waist tomorrow.
-
I have already made the molds for the crotch and buttocks, the white one is the new mold, and the gray one is the old mold made based on the sideshow statue.
-
This is the mold for thigh armor and crotch mold.
-
The hip armor mold and back waist armor mold have been completed.
-
I completed the design of the shoulder armor mold today. I reduced the concave part of the mold by 2mm twice, which is the thickness of the ABS board. This way, I can obtain a relatively accurate groove width.
-
Firstly, I conducted a rough scan of it to determine its size. The height of the ANOVOS statue is 200cm, which I believe is not suitable for most people. My height is 184cm, so I reduced it by 3% so that I can use height pads to increase my height. This is a comparison between the statue and my own scanning model.
