Easily install screen/mesh in mic tips

[DizzyStormtrooper[501st]]

you will need:

 

-mic tips

-metal screen material

-scissors

-superglue (optional)

-highlighter or dry erase marker

 

1. Cut mesh into circle a little bigger than the size of a nickel (this is so it stretches and doesnt fold)

2. Sandwich the mesh between mic tip and upside-down highlighter/marker cap like this

 

 

3. Push down slowly and evenly

 

 

 

 

you can see what i did here

 

 

 

 

4. trim the excess. this is so it goes in evenly and you dont end up mashing it down

 

 

5. pull now-bent screen out and flip it over.

you can put a bit of glue around the inside, id recommend so it wont fall out. when installing i like to use an exacto knife to evenly push in the screen from the sides

 

 

 

 

do the same with the other one and there you go!

 

[Scubacat[TX]]

This is great! I was wondering this exact thing!!!! You are a mind reader!

[Scootch[TX]]

Nice work!

[rottie[501st]]

Well i'll be ....this is awsome.......should be pinned

[DizzyStormtrooper[501st]]

I forgot to mention I got the mesh from gazmosis on fisd. He's got loads of it. Much better than the woven steel that comes apart when you cut it. This stuff bends easy, he said its made for dioramas and modeling, to make mountains and hills

[Master Tej]

Great tutorial!

 

- Master Tej -