Rods to the collapsible stock

[Tromac]

Can anyone tell me what the diameter and length of the metal rods out to the collapsible stock on the E-11D is please? Preferably in metric

[nanotek[CMD-DWM]]

Which model? Mine are 5mm I think. I can check later for you. If you can I would take the pieces to a model shop and try a couple of rods to see. I chose ones that required a bit of forcing in so they stayed in position

 

I hope this helps

[Woodo007[TX]]

If it's Tom Campbell print they are 6mm

 

 

Sent from my iPhone using Tapatalk

[Tromac]

I ended up actually going 10mm as that was all I could find at the local hardware store. Needed to drill the holes in the back of the blaster out, but the buttstock holes were already fine. Thanks for the info all.

[Tromac]

WIP shot