Suggestions to fix buckle to belt

[RageQuit[501st]]

Looking for ideas to fix my solid metal buckle to my DT belt.

I don't have a lot of depth to play with, but can bench press drill in about 3-4mm maximum, then maybe E6000 glue small nuts.

Open to any suggestion thanks.

Picture shows the back of the buckle.

 

[nanotek[CMD-DWM]]

Hey Geoff. As I suggested on Facebook, upload the pics of the thickness etc so others can chip in.

 

Here was my advice again:

 

 

“I'm not sure what you could do. My one was made by Phoenix props and has the correct 3 layers which allowed the holes to be drilled separately. I think if you try to drill into this you run the risk of either going too far, or not far enough to tap it properly.

 

A possible option would be to either glue it directly to the belt, you would need to remove the ribs and rough up the back and then glue”

 

Or

 

You create another plate with the the necessary attachment accessory and glue that to the buckle so you can fix it to the belt.