3D-files

[daniel83]

Hi! 👋🏻 

I’m going to 3D-print the armour for the scout. But before I start with that, what are the best files to use?

I got the Galactic Armory files but I’m not so sure about them.

[DarthBerry[501st]]

The Pathfinders Detachment has a list of 3D files that they've seen used (below). I don't see anything glaringly incorrect with the Galactic Armory files, but there is an analysis of all the inaccuracies in the files in a thread on the Pathfinders Detachment. GA did correct the important inaccuracies, so you should be fine as long as you've purchased the files recently and you aren't going for higher level accuracy. The Pathfinders folks confirmed that the files shouldn't have any issues with basic approval, but you may want to go find that thread for any concerns.

MrPoopie (Armor)

Jesus Salmeron (Helmet)

ChristhePropGuy (Armor and helmet)