Boot Blousing Tutorial

[Blackwatch[CMD-DCA]]

-----------------------------UPDATED MAY 2020------------------------------------------------

Troopers

Looking at the source art, the boots are short.  while we do consider the Commuter 2 boot to be preferred due to its very low height of not more than 9" while retaining the look of a simple boot , not everyone can find them .  You can use regular old Jackboots at this time, per the CRL for Level 1 approval.  If you have tall boots, ___EDITED______   

If you have taller boots tuck the legs in to give the appearance of short boots. 

OR

buy cheap round two engineer boots and cut the shaft down to 8-9 inches. 

OR

Buy the commuter II style boot which meets the intent of the new, unpublished CRL. 

UNTIL THE NEW CRL GOES INTO EFFECT, THE CURRENT CRL WILL REMAIN VALID. 

Edited May 28, 2020 by Blackwatch
updated to reflect boot apperaance

[OGRE[501st]]

Nice.  I still have some blousers from my Army days sitting in a drawer.

[LSKIV[TX]]

Just to bé sure to understand, we got thé CRL for thé IAT but now if i send my IAT's pics, it would bé better to have bloused on Boots whereas is it not "yet" wrote in thé "New" CRL.

Got few free' off duty days and Sunny Weathers if not non rainin' one...so don't want to screws everything...

[Blackwatch[CMD-DCA]]

Until we can get the CRL changed, and get the permissions to do so (*waiting on that now) match the CRL text.  In time the CRL will be updated.  We are currently writing the Sunber CRL and writing that into it, so for those that have never done it, were putting the "how to" out there. 

[LSKIV[TX]]

Ok thanks for thé answer

[nocjef[TX]]

I use these for blousing:

https://www.amazon.com/dp/B0054L6SQU/?coliid=I2BA9QMCRVBORK&colid=266MLWHX6L3A6&ref_=lv_ov_lig_dp_it&th=1

Those are now overpriced, you can get them for about $2 at an army/navy shop locally. 

[Blackwatch[CMD-DCA]]

updated to reflect boot apperance.