Boot Blousing For Imperial Army Sappers

[Blackwatch[CMD-DCA]]

-----------------------------UPDATED MAY 2020------------------------------------------------

Troopers

Looking at the source art, the boots are short.  while we do consider the Commuter 2 boot to be preferred due to its very low height of not more than 9" while retaining the look of a simple boot , not everyone can find them . Jackboots will not be approved for use for the Sapper .   

If you have taller boots tuck the legs in to give the appearance of short boots. 

OR

buy cheap round two engineer boots and cut the shaft down to 8-9 inches. 

OR

Buy the commuter II style boot which meets the intent of the new, unpublished CRL. as well as the existing CRL. 

UNTIL THE NEW CRL GOES INTO EFFECT, THE CURRENT CRL WILL REMAIN VALID. 

Boots

• "Commuter" style boot 8-9" (20-23cm) in height.
• Calf high boots such as "jackboots" or "kersey" style are not acceptable.
• Black leather or leather like material.
• Free of laces, decorative stitching, buckles or any other embellishments.
• Normal leather grain/texture/lines are acceptable.
• Tread on the soles and heels is acceptable
• Zippers on the inside of the boot are acceptable, so long as they are concealed. If not covered by leather or vinyl, zippers are painted black.

 

 

[Blackwatch[CMD-DCA]]

updated boot text May 2020