Dark Trooper - Generation 3 - Mandalorian - CRL Discussion

[Chaos[CMD-DCA]]

Apologies all, work has been a blotch, I'll get the belt done this week.

[Andreas Funk]

Hallo Chaos 

Alles klar falls du noch Bilder oder Maße benötigst, könnte ich bei mir nachschauen.

[Andreas Funk]

Hallo

Kann einer von den erfahrenen Leuten erzählen, wie lange ihr noch damit rechnet, bis das Projekt komplett durch ist ?

Gruß

 

Andreas

[Chaos[CMD-DCA]]

On 7/5/2025 at 10:21 PM, Andreas Funk said:

Hello

Can any of the experienced people tell us how long they expect it to take until the project is completely finished?

greeting

 

Andreas

Andreas, we are almost done with the CRL descriptions, once we do that, if your build matches, then we can have you take Hi resolution photos of your armor pieces and full suit up photos as reference photos to send into the Legion. New to the Legion costumes are very time consuming. I have seen some CRLs take up to 2 years start to finish. 

If I had to guess on this one, I would say probably less than 3-4 months provided we can finalize all the CRL wording, and your kit meets the wording. 

[Chaos[CMD-DCA]]

Revision 0

Belt

• The belt is smooth and ridged and creates a circular band around the wearer’s waist with no visible buckle or fastening mechanism.
• The belt has an overall width of approximately 70-80 mm. (based upon comparison to Din Djarin’s ammo canister height)
• There is one rectangular hard box approximately 105mm x 85mm, offset center to the wear’s right.
  • All four front side edges are beveled inward.
  • There is a narrow rectangular recess, approximately 80mm x 10mm, along the box’s lower front plate.
• There are two smaller rectangular hard boxes, that are side by side, approximately 52mm x 85mm offset center to the wearer’s left.
  • All four front side edges are beveled inward.
• There are two leather or leather-like material rectangular pouches to the wearer’s left side, one is approximately 52mm x 90mm and the other is approximately 52mm x 100mm. Both pouches have a top fold over flap which has a single black snap closure and covers about 3/5^th of the front of the pouch.
  • The most rearward pouch sits slightly lower on the belt than the forward pouch.
• There is one leather or leather-like material rectangular pouch to the wearer’s right side, approximately 52mm x 100mm. The pouch has a top fold over flap which has a single black snap closure and covers about 3/5th of the front of the pouch.
• There are two rectangular hard boxes, approximately 95mm x 114mm x 20mm, located aft of the wearer’s hip.
  • The boxes slant outward approximately 20-30 degrees.
  • The box has a rectangular cover with an upper to lower outward taper.
    • The lid has approximately 16-20 raised narrow details equally spaced across the front of the cover.
    • The lower edge of the cover has an inward beveled edge.
• There is a horizontal Thermal Detonator located on the rear center of the belt.
  • is a circular canister with approximately 14 evenly spaced grooves extending to the end caps and is attached to the lower back armor.
  • Width is approximately the same as the lower back plate
• Belt and belt accessories may be slightly weathered but must be uniform with the rest of the costume

[Andreas Funk]

Hallo Chaos

Was bedeutet beim dem Gürtel, er ist glatt und gerippt?

 

Gruß

 

Andreas