UP GRADING MY BUCKET

[Ruck[TX]]

[Ruck[TX]]

Then I bent the other side the same way.

[Ruck[TX]]

[Ruck[TX]]

I put the fan back inside to double check the fit and made adjustments as needed.

Then I measured the sides to bend. I then had to cut two lines for the bend.

[Ruck[TX]]

[Ruck[TX]]

But first I cut off the excess mesh always better to cut a little off then to not have enough.

[Ruck[TX]]

[Ruck[TX]]

[Ruck[TX]]

In the picture above I cut right on the bend to allow me to bend that piece with out any over hanging piece, both are flat.

[Ruck[TX]]

Once I cut both sides I bent in both tabs over each other.

[Ruck[TX]]

[Ruck[TX]]

Then I bent the other piece over the two pieces I just bent.

[Ruck[TX]]

[Ruck[TX]]

Then I bent the tab that will go against the bucket and hold it in place.nd]

[Ruck[TX]]

[Ruck[TX]]

I then copied what I just did to the other side.

[Ruck[TX]]

[Ruck[TX]]

[Ruck[TX]]

[Ruck[TX]]

[Ruck[TX]]

Then I bent the other piece over the two pieces I just bent.

[Ruck[TX]]

[Ruck[TX]]

Then I bent the tab that will go against the bucket and hold it in place.

[Ruck[TX]]

I then copied what I just did to the other side.

[Ruck[TX]]