Purge Trooper (Phase II) - Kenobi - Discussion

[IcyTrooper[CMD-DL]]

There is going to be a small correction to the helmet text about the LED. The changes are in orange:

• Symmetrical rectangular greebles (communicators/range finders) with semi-circular ridges underneath, present at the back of each side of the brow band, situated on top of the point where the front band meets the rear groove.
  • The greeblie contains two raised and stacked squares, each with a circular LED or sculpted imitation located near the front, and a single recessed line in the shape of a square outlining the back two thirds of the greeble. If LEDs are used, the top LED must be a warm pale yellow (similar to a warm incandescent bulb) and the bottom LED must be red.
• There are 2 small pill shaped double indentation in the bottom corners of the faceplate, under each ear. The rear indentation is vertical and slightly longer than the front indentation that angles toward the front of the helmet. 

OPTIONAL Level two certification (if applicable):

• The central vocoder (chin detail) shall be molded as a separate piece and is inserted into a recess in the mouth plate.
• The aforementioned greeblie on the back of each side of the brow band must have the top and bottom lit using LEDs. The top LED must be a warm pale yellow (similar to a warm incandescent bulb), the bottom LED must be red.

[smoszer]

Sounds good. Pretty minor. 

[IcyTrooper[CMD-DL]]

The CRL is live!

https://databank.501st.com/databank/Costuming:Purge_trooper_p2

[jakebullet[501st]]

1 hour ago, IcyTrooper said:

The CRL is live!

https://databank.501st.com/databank/Costuming:Purge_trooper_p2

I guess I'd better get on with it then! Thanks guys for all your hard work with this 

 

[tipperaryred[CMD-DCA]]

Huge thanks to everyone that assisted with this project. We had to rely on convention photos, behind the scenes insights, scale models and more to make up for the limited on screen references. Fantastic to see it complete.