gmrhodes13

Looks good. From the visual dictionary

Looks good, I guess it could be added as an optional material.

Looks good, not sure about this There are 45-47 degree recessed lines that run around the inner bicep (the lines are angled at those degrees or there are that many lines total?)

Added measurements and some text

Would it be better moving the actual amount of lines/ridges to a L2 requirement and not for basic approval? I agree with the additions and removed text Perhaps allow satin black as it has been added in other areas of the CRL. Each tear (area beneath the corners of lens frame) contains the following details: Solid matte black. Solid matte or satin black Measurements added The base of the channel is black is about 8mm wide by 8mm deep (corresponding inch measures) (5/16 inch) The bottom of the helmet has a black ledge that runs the perimeter of the helmet that extends back into the interior. Black ledge is approx. 3/4" to 1" wide. (mm measures too please) (19mm - 25mm)

Looks good

Looks good. Unfortunately I don't have a good screen reference of the right side of the TD, I have seen the standee, floor trooper and display troopers all look the same though.

Looks good

Looks good

Personally I would attempt to fix, but it also doesn't appear to have the curved cut out section on the side so you may need to do some more work there.

Looking good, nice work

I used an automotive acrylic paint in spray can it's a base red , not sure what others are using

If you use the "direct link" it should show in the post Well there you go, black mesh, BUT most others appear to have silver, could be a spare who knows.

Most of us use an online image host such as Imgur, upload then copy the link to the photo and paste it into your post. With the one with the screen you see above you can't see through it, remember those are from a prop show too. Screen images are showing they do have screen

Here it is being held

Just under 6ft

Finally have someone on hand to help get kitted up and take some photos

Looks good

I don't normally see dimensions on most CRL's (I think IOC is about the only one) really depends how difficult you want L2 to be. Personally I would say either NO are add in "as close to" or "approximate" to the wording.

Personally I would also allow "satin" black (in fact for all black pieces), in some of the images you can see a shine to the black which "matte" does not give

All good here @nanotek

I'm not sure if the two front boxes use spacers/risers, in the images there is little to no gap, I think because these boxes are on a slight V, but the side boxes definitely do have spacers/risers (thinner in the middle of the boxes so either a material which compresses or is curved to match the belt) which appears to keep them outwards away from the thighs. Any thoughts? I could be over thinking it and they may actually be quite compressed on the front. Perhaps drop the thickness from L1 and move to L2

Looks good

Looks good, just wondering if we could modify the following, or bring to L2, at the end of the day if it doesn't appear to have a visible opening it shouldn't matter where the join is as long as it can't be seen for basic approval. Has no visible openings or fasteners with each end of the belt connecting behind the front horizontal boxes Has no visible openings or fasteners ideally each end of the belt connecting behind the front horizontal boxes Or OPTIONAL Level two certification (if applicable): Each end of the belt must connect behind the front horizontal boxes

Weather has been turning cold here but great timing a nice warm weekend and managed to get the painting done.